| Pattern Corrections - If you find a problem with any of the instructions and the solution is not here, please contact me! |
 |
| ArtFabric Studio Kits |
| |
Catchit Frog: The lily pad pattern was accidentally left out of a small number of patterns. If your Catchit Frog kit is missing the lily pad pattern, please email me and I will send you one at once.
FishLips: #10, page 2 should read: FishLips’ lips: Fold each 1.75”X7” bias strip in half lengthwise (wrong sides together) to measure 7/8”X7”. |
| Susa Glenn Designs Bag and Tote Kits |
| |
The Large Asian Tote:
instructions page 2 step 2 should read: Prepare the zipper slot: Pin (right sides together) one of the 8”X8” pocket squares to the right side of the lining. Line up the top edge of the pocket square with the top edge of the zipper interfacing Pin at each pocket corner to keep orderly. Turn over. Using the center narrow rectangle that you cut out of the iron-on interfacing as your guide, sew the pocket piece and the lining together around the edge of this narrow rectangle only. Use small stitches and at each corner pivot with your needle down. Carefully cut a slit down the center of this narrow rectangle to 1/4” from each end. Snip diagonally deeply into each corner of the zipper slot but do not cut your stitching thread. Pull the pocket fabric through the slit. Smooth it down and adjust the seam line. Carefully press with an iron so that the pocket fabric does not show from the lining fabric side and the rectangle is sharp and clean.
page 3, step 11, assemble the bag bottom insert: In addition to taping the Bag Structure together to make the bag bottom insert, use a household stapler and staple the overlapping pieces to insure strength and stability.
HTCW brand sew-in craft weight interfacing #9260 is recommended instead of felt for the interfacing.
The Bohemian Bag:
Question: I'm sewing the Bohemian Bag and have read your instructions
several times. On page 3, item #3, you
said to "cut 6 strips 2-3/8" wide and at least 22" long. Stack the strips (right sides up) together"........
did you mean to say for me to cut 6 strips ON THE BIAS each strip 2-3/8"
wide and at least 22" long since your LINING cutting instructions on page
1 shows these strips to be on the bias??
Answer: Yes, cut the strips for the handles on the bias.
|
| Susa Glenn Designs Bag and Tote Kits |
| |
The Origami Bag:
When making the freezer paper pattern for the large size Origami bag, you should first cut two pieces of freezer paper and tape them together with masking tape so that the freezer paper will be wide enough to make the pattern.
The Out on the Town Bag:
A few patterns that were sold in September are missing page 5. If your pattern is missing page 5, please email me and I will email you the replacement page at once.
|
| Susa Glenn Designs Embroidery Products |
| |
The Bee's Knees Bag:
There are some scaling issues regarding the first printing of this project's CD (January, 2006). The printed templates are not sized correctly in relationship to the bag's pattern. If you find that you have one of the CD's with this error, please email me and I will email you the correction.
Sunflowers & Bees Embroidered Flanged Pillows:
The assembly instructions did not include the interfacing for the pillow front. The instructions should read: Place the pillow front’s interfacing on the table.
Lay the pillow front right side up on top. Lay the back half with the
button hole onto the front (right sides together). Lay the back half
without the buttonhole onto the project. The back halves will overlap
about 2”. Pin together.
|
